Peter Cost
2018-11-30 08:06:43 UTC
Dear Reader,
I have a SIL3114 PCI board with an Intel N28F010-120 flash chip on it,
and I can't reprogram it since it lacks the 12V Vpp. I checked that
there is no +12V connection on the PCI edge connector of the board and
the VPP pin seems to be unconnected.
My question is this. When I apply 12V Vpp to the chip will I then be
able to reprogram the board with the Lattice (Silicon Image) dos utility
or the flashrom utility.
I am an experienced engineer, but my eprom day's are from way back in
the 80's and early 90's and I have never done anything with flash proms
other than reprogramming boards with the supplied software.
Thanks for any response.
Kind regards,
Peter Cost
I have a SIL3114 PCI board with an Intel N28F010-120 flash chip on it,
and I can't reprogram it since it lacks the 12V Vpp. I checked that
there is no +12V connection on the PCI edge connector of the board and
the VPP pin seems to be unconnected.
My question is this. When I apply 12V Vpp to the chip will I then be
able to reprogram the board with the Lattice (Silicon Image) dos utility
or the flashrom utility.
I am an experienced engineer, but my eprom day's are from way back in
the 80's and early 90's and I have never done anything with flash proms
other than reprogramming boards with the supplied software.
Thanks for any response.
Kind regards,
Peter Cost